ABB ACS880 Firmware Manual page 145

No. Name/Value
DDCS controller
Application
Program
ATF
20.02 Ext1 start trigger
type
Edge
Level
20.03 Ext1 in1 source
Not selected
Selected
DI1
DI2
DI3
DI4
DI5
DI6
DIO1
DIO2
Other [bit]
20.04 Ext1 in2 source
20.05 Ext1 in3 source
20.06 Ext2 commands
Not selected
In1 Start
Description
The start and stop commands are taken from an external
(DDCS) controller.
Note: Set also 20.02 Ext1 start trigger type
The start and stop commands are taken from the application
program control word (parameter
word).
Note: Set also 20.02 Ext1 start trigger type
Reserved.
Defines whether the start signal for external control location
EXT1 is edge-triggered or level-triggered.
Note: This parameter is not effective if a pulse-type start
signal is selected. See the descriptions of the selections of
parameter 20.01 Ext1 commands.
The start signal is edge-triggered.
The start signal is level-triggered.
Selects source 1 for parameter
0 (always off).
1 (always on).
Digital input DI1 (10.02 DI delayed
Digital input DI2 (10.02 DI delayed
Digital input DI3 (10.02 DI delayed
Digital input DI4 (10.02 DI delayed
Digital input DI5 (10.02 DI delayed
Digital input DI6 (10.02 DI delayed
Digital input/output DIO1
Digital input/output DIO2
Source selection (see Terms and abbreviations
Selects source 2 for parameter
For the available selections, see parameter
source.
Selects source 3 for parameter
For the available selections, see parameter
source.
Selects the source of start, stop and direction commands for
external control location 2 (EXT2).
See also parameters 20.07...20.10.
No start or stop command sources selected.
The source of the start and stop commands is selected by
parameter 20.08 Ext2 in1
source bits are interpreted as follows:
State of source 1 (20.08)
0 -> 1 (20.07 = Edge)
1 (20.07 = Level)
0
to Level.
06.02 Application control
to Level.
20.01 Ext1 commands.
status, bit 0).
status, bit 1).
status, bit 2).
status, bit 3).
status, bit 4).
status, bit 5).
(11.02 DIO delayed status, bit 0).
(11.02 DIO delayed status, bit 1).
on page 88).
20.01 Ext1 commands.
20.03 Ext1 in1
20.01 Ext1 commands.
20.03 Ext1 in1
source. The state transitions of the
Command
Start
Stop
Parameters 145
Def/FbEq16
16
21
22
Edge
0
1
DI1
0
1
2
3
4
5
6
7
10
11
-
DI2
Not selected
Not selected
0
1