ABB ACS880 Firmware Manual page 96

96 Parameters
No. Name/Value
06.16 Drive status word 1
Bit Name
0 Enabled
1 Inhibited
2 DC charged 1 = DC circuit has been charged
3 Ready to
start
4 Following
reference
5 Started
6 Modulating
7 Limiting
8 Local control 1 = Drive is in local control
9 Network ctrl 1 = Drive is in
10 Ext1 active
11 Ext2 active
12 Reserved
13 Start request 1 = Start requested
14...15 Reserved
0000h...FFFFh
06.17 Drive status word 2
Bit Name
0 Identification run done 1 = Motor identification (ID) run has been performed
1 Magnetized
2 Torque control
3 Speed control
4 Power control
5 Safe reference active
6 Last speed active
7 Loss of reference
8 Emergency stop failed 1 = Emergency stop failed (see parameters
9 Jogging active
10 Above limit
11...15 Reserved
0000h...FFFFh
Description
Drive status word 1.
This parameter is read-only.
Description
1 = Both run enable (see par. 20.12) and start enable (20.19) signals are
present. Note: This bit is not affected by the presence of a fault.
1 = Start inhibited. To start the drive, the inhibiting signal (see par. 06.18)
must be removed and the start signal cycled.
1 = Drive is ready to receive a start command
1 = Drive is ready to follow given reference
1 = Drive has been started
1 = Drive is modulating (output stage is being controlled)
1 = Any operating limit (speed, torque, etc.) is active
network control
1 = Control location EXT1 active
1 = Control location EXT2 active
Drive status word 1.
Drive status word 2.
This parameter is read-only.
Description
1 = The motor has been magnetized
1 = Torque control mode active
1 = Speed control mode active
1 = Power control mode active
1 = A "safe" reference is applied by functions such as
parameters 49.05
1 = A "last speed" reference is applied by functions such as
parameters 49.05
1 = Reference signal lost
1 = Jogging enable signal is on
1 = Actual speed, frequency or torque equals or exceeds limit
(defined by parameters 46.31...46.33). Valid in both directions of
rotation.
Drive status word 2.
(see page 14)
and 50.02
and 50.02
Def/FbEq16
-
1 = 1
-
31.32 and 31.33)
1 = 1