ABB ACS880 Firmware Manual page 200

200 Parameters
No. Name/Value
No indication/No
indication
31.23 Cross connection
No action
Fault
31.24 Stall function
No action
Warning
Fault
31.25 Stall current limit
0.0 ... 1600.0%
31.26 Stall speed limit
0.00 ... 10000.00
rpm
31.27 Stall frequency limit
0.00 ... 500.00 Hz
31.28 Stall time
0 ... 3600 s
Description
Inputs
Indication (running or stopped)
IN1 IN2
0 0
0 1 Fault
1 0 Fault
1 1
Selects how the drive reacts to incorrect input power and
motor cable connection (i.e. input power cable is connected
to drive motor connection).
No action taken.
The drive trips on fault 3181 Cross
Selects how the drive reacts to a motor stall condition.
A stall condition is defined as follows:
• The drive exceeds the stall current limit
limit), and
• the output frequency is below the level set by parameter
31.27 Stall frequency limit
level set by parameter
• the conditions above have been true longer than the time
set by parameter 31.28 Stall
None (stall supervision disabled).
The drive generates an
The drive trips on fault 7121 Motor
Stall current limit in percent of the nominal current of the
motor. See parameter 31.24 Stall
Stall current limit.
Stall speed limit in rpm. See parameter
Stall speed limit.
Stall frequency limit. See parameter
Note: Setting the limit below 10 Hz is not recommended.
Stall frequency limit.
Stall time. See parameter
Stall time.
None
FA81 Safe torque off 1
FA82 Safe torque off 2
(Normal operation)
connection.
(31.25 Stall current
or the motor speed is below the
31.26 Stall speed limit, and
time.
A780 Motor stall warning.
stall.
function.
31.24 Stall
31.24 Stall function.
31.24 Stall function.
Def/FbEq16
5
Fault
0
1
Fault
0
1
2
200.0%
-
function. 150.00 rpm
See par.
46.01
15.00 Hz
See par.
46.02
20 s
-