Encoder 2 Configuration - ABB ACS880 Firmware Manual

290 Parameters
No. Name/Value
92.47 Hiperface node
address
0...255
92
93 Encoder 2
configuration
93.01 Encoder 2 type
None
TTL
TTL+
Abs enc
Resolver
HTL
93.02 Encoder 2 source
Module 1
Module 2
93.10 Pulses/rev
93.10 Sine/cosine number
93.10 Excitation signal
frequency
93.11 Pulse encoder type
93.11 Absolute position
source
93.11 Excitation signal
amplitude
93.12 Speed calculation
mode
93.12 Zero pulse enable
Description
(Visible when 92.01 Encoder 1 type
Defines the node address for a HIPERFACE encoder.
Typically this parameter need not be set.
HIPERFACE encoder node address.
Settings for encoder 2.
Notes:
• The contents of the parameter group vary according to the
selected encoder type.
• It is recommended that encoder connection 1 (group
Encoder 1 configuration) is used whenever possible since
the data received through that interface is fresher than the
data received through connection 2 (this group).
Activates the communication with optional encoder/resolver
interface module 2.
Inactive.
Communication active. Module type: FEN-01 TTL Encoder
Interface. Input: TTL encoder input (X31).
Communication active. Module type: FEN-01 TTL Encoder
interface. Input: TTL encoder input with commutation support
(X32).
Communication active. Module type: FEN-11 Absolute
Encoder Interface. Input: Absolute encoder input (X42).
Communication active. Module type: FEN-21 Resolver
Interface. Input: Resolver input (X52).
Communication active. Module type: FEN-31 HTL Encoder
Interface. Input: HTL encoder input (X82).
Selects the interface module that the encoder is connected
to. (The physical locations and types of encoder interface
modules are defined in parameter group
settings.)
Interface module 1.
Interface module 2.
(Visible when 93.01 Encoder 2 type
See parameter 92.10 Pulses/rev.
(Visible when 93.01 Encoder 2 type
See parameter 92.10 Sine/cosine
(Visible when 93.01 Encoder 2 type
See parameter 92.10 Excitation signal
(Visible when 93.01 Encoder 2 type
See parameter 92.11 Pulse encoder
(Visible when 93.01 Encoder 2 type
See parameter 92.11 Absolute position
(Visible when 93.01 Encoder 2 type
See parameter 92.11 Excitation signal
(Visible when 93.01 Encoder 2 type
See parameter 92.12 Speed calculation
(Visible when 93.01 Encoder 2 type
See parameter 92.12 Zero pulse
= Abs enc)
92
91 Encoder module
= TTL, TTL+ or HTL)
= Abs enc)
number.
= Resolver)
frequency.
= TTL, TTL+ or HTL)
type.
= Abs enc)
source.
= Resolver)
amplitude.
= TTL, TTL+ or HTL)
mode.
= Abs enc)
enable.
Def/FbEq16
64
-
None
0
1
2
3
4
5
Module 1
1
2
2048
0
1 kHz
Quadrature
None
4.0 V
Auto rising
Disable