Terms And Abbreviations - ABB ACS880 Firmware Manual

88 Parameters

Terms and abbreviations

Term
Actual signal
Def
FbEq16
Other
Other [bit]
Parameter
p.u.
Definition
Type of parameter that is the result of a measurement or calculation by
the drive, or contains status information. Most actual signals are read-
only, but some (especially counter-type actual signals) can be reset.
(In the following table, shown on the same row as the parameter name)
The default value of a parameter
information on other macro-specific parameter values, see chapter
Application macros (page 71).
Note: Optional equipment may require different default values to those
listed. See parameter 95.20 HW options word
(In the following table, shown on the same row as the parameter range,
or for each selection)
16-bit fieldbus equivalent: The scaling between the value shown on the
panel and the integer used in communication when a 16-bit value is
selected for transmission to an external system.
A dash (-) indicates that the parameter is not accessible in 16-bit format.
The corresponding 32-bit scalings are listed in chapter
parameter data (page 309).
The value is taken from another parameter.
Choosing "Other" displays a parameter list in which the user can specify
the source parameter.
The value is taken from a specific bit in another parameter.
Choosing "Other" displays a parameter list in which the user can specify
the source parameter and bit.
Either a user-adjustable operating instruction for the drive, or an
signal.
Per unit
when used in the Factory macro. For
1.
Additional
actual