Brake Chopper - ABB ACS880 Firmware Manual

No. Name/Value
41.40 Set 2 deadband
delay
41.41 Set 2 sleep mode
41.42 Set 2 sleep enable
41.43 Set 2 sleep level
41.44 Set 2 sleep delay
41.45 Set 2 sleep boost
time
41.46 Set 2 sleep boost
step
41.47 Set 2 wake-up
deviation
41.48 Set 2 wake-up
delay
41.49 Set 2 tracking mode
41.50 Set 2 tracking ref
selection
41.51 Set 2 trim mode
41.52 Set 2 trim selection
41.53 Set 2 trimmed ref
pointer
41.54 Set 2 trim mix
41.55 Set 2 trim adjust
41.56 Set 2 trim source
43

43 Brake chopper

43.01 Braking resistor
temperature
0.0 ... 120.0%
43.06 Brake chopper
enable
Disabled
Enabled with
thermal model
Description
See parameter 40.40 Set 1 deadband
See parameter 40.41 Set 1 sleep
See parameter 40.42 Set 1 sleep
See parameter 40.43 Set 1 sleep
See parameter 40.44 Set 1 sleep
See parameter 40.45 Set 1 sleep boost
See parameter 40.46 Set 1 sleep boost
See parameter 40.47 Set 1 wake-up
See parameter 40.48 Set 1 wake-up
See parameter 40.49 Set 1 tracking
See parameter 40.50 Set 1 tracking ref
See parameter 40.51 Set 1 trim
See parameter 40.52 Set 1 trim
See parameter 40.53 Set 1 trimmed ref
See parameter 40.54 Set 1 trim
See parameter 40.55 Set 1 trim
See parameter 40.56 Set 1 trim
Settings for the internal brake chopper.
Displays the estimated temperature of the brake resistor, or
how close the brake resistor is to being too hot.
The value is given in percent where 100% is the temperature
the resistor would reach if the maximum continuous braking
power (43.09 Brake resistor Pmax
resistor for 100% rated time. The thermal time constant
(43.08 Brake resistor thermal
achieve 63% temperature. 100% would be reached when
100% time has elapsed.
This parameter is read-only.
Estimated brake resistor temperature.
Enables brake chopper control.
Note: Before enabling brake chopper control, ensure that
• a brake resistor is connected
• overvoltage control is switched off (parameter
Overvoltage control)
• the supply voltage range (parameter
has been selected correctly.
Brake chopper control disabled.
Brake chopper control enabled with resistor overload
protection.
delay.
mode.
enable.
level.
delay.
time.
step.
deviation.
delay.
mode.
selection.
mode.
selection.
pointer.
mix.
adjust.
source.
cont) is applied to the
tc) defines the rated time to
30.30
95.01 Supply voltage)
Parameters 239
Def/FbEq16
0.0 s
Not selected
Not selected
0.0
60.0 s
0.0 s
0.0
0.00
0.50 s
Not selected
Not selected
Off
Torque
Not selected
0.000
1.000
PID ref
-
1 = 1%
Disabled
0
1