ABB ACS880 Firmware Manual page 193

No. Name/Value
DI1
DI2
DI3
DI4
DI5
DI6
DIO1
DIO2
Other [bit]
30.19 Minimum torque 1
-1600.0 ... 0.0%
30.20 Maximum torque 1
0.0 ... 1600.0%
30.21 Minimum torque 2
source
Zero
AI1 scaled
AI2 scaled
PID
Minimum torque 2
Other
30.22 Maximum torque 2
source
Zero
Description
Digital input DI1 (10.02 DI delayed
Digital input DI2 (10.02 DI delayed
Digital input DI3 (10.02 DI delayed
Digital input DI4 (10.02 DI delayed
Digital input DI5 (10.02 DI delayed
Digital input DI6 (10.02 DI delayed
Digital input/output DIO1
Digital input/output DIO2
Source selection (see Terms and abbreviations
Defines a minimum torque limit for the drive (in percent of
nominal motor torque). See diagram at parameter
Minimum torque sel.
The limit is effective when
• the source selected by
• 30.18 is set to Minimum torque
Minimum torque limit 1.
Defines a maximum torque limit for the drive (in percent of
nominal motor torque). See diagram at parameter
Minimum torque sel.
The limit is effective when
• the source selected by
• 30.25 is set to Torque limit set
Maximum torque 1.
Defines the source of the minimum torque limit for the drive
(in percent of nominal motor torque) when
• the source selected by parameter
sel is 1, or
• 30.18 is set to Minimum torque 2
See diagram at 30.18 Minimum torque
Note: Any positive values received from the selected source
are inverted.
None.
12.12 AI1 scaled value (see page 113).
12.22 AI2 scaled value (see page 114).
40.01 Process PID output actual
controller).
30.23 Minimum torque 2.
Source selection (see Terms and abbreviations
Defines the source of the maximum torque limit for the drive
(in percent of nominal motor torque) when
• the source selected by parameter
sel is 1, or
• 30.25 is set to Torque limit set
See diagram at 30.18 Minimum torque
Note: Any negative values received from the selected source
are inverted.
None.
status, bit 0).
status, bit 1).
status, bit 2).
status, bit 3).
status, bit 4).
status, bit 5).
(11.02 DIO delayed status, bit 0).
(11.02 DIO delayed status, bit 1).
on page 88).
30.18 Minimum torque sel
1.
30.25 Maximum torque sel
1.
30.18 Minimum torque
source.
sel.
(output of the process PID
on page 88).
30.25 Maximum torque
2.
sel.
Parameters 193
Def/FbEq16
2
3
4
5
6
7
10
11
-
-300.0%
30.18
is 0, or
See par.
46.03
300.0%
30.18
is 0, or
See par.
46.03
Minimum
torque 2
0
1
2
5
6
-
Maximum
torque 2
0