ABB ACS880 Firmware Manual page 366

366 Fault tracing
Code
Fault
(hex)
5681 PU communication
5682 Power unit lost
5690 PU communication
internal
5691 Measurement circuit
ADC
5692 PU board powerfail
5693 Measurement circuit
DFF
5694 PU communication
configuration
5696 PU state feedback
5697 Charging feedback
5698 Unknown power unit
fault
6180 Internal SW error
6181 FPGA version
incompatible
6306 FBA A mapping file
6307 FBA B mapping file
6481 Task overload
6487 Stack overflow
64A1 Internal file load
64A2 Internal record load
64A3 Application loading
Cause
Communication errors
detected between the drive
control unit and the power unit.
Connection between the drive
control unit and the power unit
is lost.
Internal communication error.
Measurement circuit fault.
Power unit power supply
failure.
Measurement circuit fault.
Version check cannot find a
matching power unit FPGA
logic.
State feedback from output
phases does not match control
signals.
Charging feedback signal
missing.
Unidentified power unit logic
fault.
Internal error.
Firmware and FPGA versions
are incompatible.
Fieldbus adapter A mapping
file read error.
Fieldbus adapter B mapping
file read error.
Internal fault.
Note: This fault cannot be
reset.
Internal fault.
Note: This fault cannot be
reset.
File read error.
Note: This fault cannot be
reset.
Internal record load error.
Application file incompatible or
corrupted.
Note: This fault cannot be
reset.
What to do
Check the connection between the drive
control unit and the power unit.
Check the connection between the
control unit and the power unit.
Contact your local ABB representative.
Contact your local ABB representative.
Contact your local ABB representative.
Contact your local ABB representative.
Update the FPGA logic of the power unit.
Contact your local ABB representative.
Contact your local ABB representative.
Check the feedback signal coming from
the charging system.
Check power unit logic and firmware
compatibility.
Contact your local ABB representative.
Contact your local ABB representative.
Quote the auxiliary code (check the
event details in the event log).
Update power unit FPGA logic or
firmware (whichever is older).
Contact your local ABB representative.
Contact your local ABB representative.
Contact your local ABB representative.
Contact your local ABB representative.
Contact your local ABB representative.
Contact your local ABB representative.
Contact your local ABB representative.
Contact your local ABB representative.