ABB ACS880 Firmware Manual page 198

198 Parameters
No. Name/Value
31.16 Delay time
0.0 ... 120.0 s
31.19 Motor phase loss
No action
Fault
31.20 Earth fault
No action
Warning
Fault
31.21 Supply phase loss
No action
Fault
31.22 STO indication
run/stop
Fault/Fault
Description
Defines the time that the drive will wait after a fault before
attempting an automatic reset. See parameter
Autoreset selection.
Autoreset delay.
Selects how the drive reacts when a motor phase loss is
detected.
No action taken.
The drive trips on fault 3381 Output phase
Selects how the drive reacts when an earth fault or current
unbalance is detected in the motor or the motor cable.
No action taken.
The drive generates an
The drive trips on fault 2330 Earth
Selects how the drive reacts when a supply phase loss is
detected.
No action taken.
The drive trips on fault 3130 Input phase
Selects which indications are given when one or both Safe
torque off (STO) signals are switched off or lost. The
indications also depend on whether the drive is running or
stopped when this occurs.
The tables at each selection below show the indications
generated with that particular setting.
Notes:
• This parameter does not affect the operation of the STO
function itself. The STO function will operate regardless of
the setting of this parameter: a running drive will stop upon
removal of one or both STO signals, and will not start until
both STO signals are restored and all faults reset.
• The loss of only one STO signal always generates a fault
as it is interpreted as a malfunction.
For more information on the STO, see the Hardware manual
of the drive.
Inputs
Indication (running or stopped)
IN1 IN2
0 0
Faults 5091 Safe torque off
0 1
Faults 5091 Safe torque off
1 0
1 1
31.12
loss.
A2B3 Earth leakage warning.
leakage.
loss.
Fault 5091 Safe torque off
and
torque off 1
and
torque off 2
(Normal operation)
Def/FbEq16
0.0 s
10 = 1 s
Fault
0
1
Fault
0
1
2
Fault
0
1
Fault/Fault
0
FA81 Safe
FA82 Safe