ABB ACS880 Firmware Manual page 165

Primary control program
Hide thumbs Also See for ACS880:
Table of Contents

Advertisement

No.
Name/Value
DI6
DIO1
DIO2
Other [bit]
23.12
Acceleration time 1
0.000 ...1800.000 s Acceleration time 1.
23.13
Deceleration time 1
0.000 ...1800.000 s Deceleration time 1.
23.14
Acceleration time 2
0.000 ...1800.000 s Acceleration time 2.
23.15
Deceleration time 2
0.000 ...1800.000 s Deceleration time 2.
Description
Digital input DI6
(10.02 DI delayed
Digital input/output DIO1
Digital input/output DIO2
Source selection (see
Terms and abbreviations
Defines acceleration time 1 as the time required for the speed
to change from zero to the speed defined by parameter
Speed scaling
(not to parameter
If the speed reference increases faster than the set
acceleration rate, the motor speed will follow the acceleration
rate.
If the speed reference increases slower than the set
acceleration rate, the motor speed will follow the reference.
If the acceleration time is set too short, the drive will
automatically prolong the acceleration in order not to exceed
the drive torque limits.
Defines deceleration time 1 as the time required for the speed
to change from the speed defined by parameter
scaling
(not from parameter
If the speed reference decreases slower than the set
deceleration rate, the motor speed will follow the reference.
If the reference changes faster than the set deceleration rate,
the motor speed will follow the deceleration rate.
If the deceleration rate is set too short, the drive will
automatically prolong the deceleration in order not to exceed
drive torque limits (or not to exceed a safe DC link voltage). If
there is any doubt about the deceleration time being too
short, ensure that DC overvoltage control is on (parameter
30.30 Overvoltage
control).
Note: If a short deceleration time is needed for a high inertia
application, the drive should be equipped with braking
equipment such as a brake chopper and brake resistor.
Defines acceleration time 2. See parameter
Acceleration time
1.
Defines deceleration time 2. See parameter
Deceleration time
1.
status, bit 5).
(11.02 DIO delayed
status, bit 0).
(11.02 DIO delayed
status, bit 1).
on page 88).
30.12 Maximum
46.01 Speed
30.12 Maximum
speed) to zero.
23.12
23.13
Parameters 165
Def/FbEq16
7
10
11
-
20.000 s
46.01
speed).
10 = 1 s
20.000 s
10 = 1 s
60.000 s
10 = 1 s
60.000 s
10 = 1 s

Advertisement

Table of Contents
loading

Table of Contents