ABB ACS880 Firmware Manual page 144

144 Parameters
No. Name/Value
In1P Start; In2 Stop
In1P Start; In2 Stop;
In3 Dir
In1P Start fwd; In2P
Start rev; In3 Stop
Fieldbus A
D2D or M/F link
Description
The sources of the start and stop commands are selected by
parameters 20.03 Ext1 in1 source
The state transitions of the source bits are interpreted as
follows:
State of source 1
(20.03)
0 - > 1
Any
Notes:
• Parameter 20.02 Ext1 start trigger type
this setting.
• When source 2 is 0, the Start and Stop keys on the control
panel are disabled.
The sources of the start and stop commands are selected by
parameters 20.03 Ext1 in1 source
The source selected by
direction. The state transitions of the source bits are
interpreted as follows:
State of State of
source 1 source 2
(20.03) (20.04)
0 - > 1
1
0 - > 1
1
Any 0
Notes:
• Parameter 20.02 Ext1 start trigger type
this setting.
• When source 2 is 0, the Start and Stop keys on the control
panel are disabled.
The sources of the start and stop commands are selected by
parameters 20.03 Ext1 in1
20.05 Ext1 in3 source. The source selected by
source determines the direction. The state transitions of the
source bits are interpreted as follows:
State of State of
source 1 source 2
(20.03) (20.04)
0 - > 1
Any
0 - > 1
Any
Any Any
Note: Parameter 20.02 Ext1 start trigger type
with this setting.
The start and stop commands are taken from fieldbus adapter
A.
Note: Set also 20.02 Ext1 start trigger type
The start and stop commands are taken from another drive
through the D2D (Drive-to-drive) link or the master/follower
link.
Note: Set also 20.02 Ext1 start trigger type
and 20.04 Ext1 in2
State of source 2
(20.04)
1
0
has no effect with
and 20.04 Ext1 in2
20.05 Ext1 in3 source determines the
State of
source 3
(20.05)
0
1
Any
has no effect with
source, 20.04 Ext1 in2 source
20.05 Ext1 in3
State of
source 3
(20.05)
1
1
0
has no effect
to Level.
to Level.
Def/FbEq16
4
source.
Command
Start
Stop
5
source.
Command
Start forward
Start reverse
Stop
6
and
Command
Start forward
Start reverse
Stop
12
15