ABB ACS880 Firmware Manual page 130

130 Parameters
No. Name/Value
14.59 AI3 HW switch
position
V
mA
14.60 AI3 unit selection
V
mA
14.61 AI3 filter gain
No filtering
125 us
250 us
500 us
1 ms
2 ms
4 ms
7.9375 ms
Description
(Visible when 14.01 Module 1 type
Shows the position of the hardware current/voltage selector
on the I/O extension module.
Note: The setting of the current/voltage selector must match
the unit selection made in parameter
I/O module reboot either by cycling the power or through
parameter 96.08 Control board boot
any changes in the hardware settings.
Volts.
Milliamperes.
(Visible when 14.01 Module 1 type
Selects the unit for readings and settings related to analog
input AI3.
Note: This setting must match the corresponding hardware
setting on the I/O extension module (see the manual of the
I/O extension module). The hardware setting is shown by
parameter 14.59 AI3 HW switch
either by cycling the power or through parameter
Control board boot is required to validate any changes in the
hardware settings.
Volts.
Milliamperes.
(Visible when 14.01 Module 1 type
Selects a hardware filtering time for AI3.
See also parameter 14.62 AI3 filter
No filtering.
125 microseconds.
250 microseconds.
500 microseconds.
1 millisecond.
2 milliseconds.
4 milliseconds.
7.9375 milliseconds.
= FIO-11)
14.60 AI3 unit selection.
is required to validate
= FIO-11)
position. I/O module reboot
96.08
= FIO-11)
time.
Def/FbEq16
-
2
10
mA
2
10
No filtering
0
1
2
3
4
5
6
7