Start/Stop/Direction - ABB ACS880 Firmware Manual

No. Name/Value
20

20 Start/stop/direction

20.01 Ext1 commands
Not selected
In1 Start
In1 Start; In2 Dir
In1 Start fwd; In2
Start rev
Description
Start/stop/direction and run/start/jog enable signal source
selection; positive/negative reference enable signal source
selection.
For information on control locations, see section
vs. external control (page 20).
Selects the source of start, stop and direction commands for
external control location 1 (EXT1).
See also parameters 20.02...20.05.
No start or stop command sources selected.
The source of the start and stop commands is selected by
parameter 20.03 Ext1 in1
source bits are interpreted as follows:
State of source 1 (20.03)
0 - > 1
(20.02 = Edge)
1 (20.02 = Level)
0
The source selected by
signal; the source selected by
determines the direction. The state transitions of the source
bits are interpreted as follows:
State of source 1
(20.03)
0
0 - > 1
(20.02 = Edge)
1 (20.02 = Level)
The source selected by
start signal; the source selected by
the reverse start signal. The state transitions of the source
bits are interpreted as follows:
State of source 1
(20.03)
0
0 - > 1
(20.02 = Edge)
1 (20.02 = Level)
0
1
source. The state transitions of the
Command
Start
Stop
20.03 Ext1 in1 source is the start
20.04 Ext1 in2 source
State of source 2
(20.04)
Any
0
1
20.03 Ext1 in1 source is the forward
20.04 Ext1 in2 source
State of source 2
(20.04)
0
0
0 -> 1 (20.02 = Edge)
1 (20.02 = Level)
1
Parameters 143
Def/FbEq16
Local control
In1 Start; In2
Dir
0
1
2
Command
Stop
Start forward
Start reverse
3
is
Command
Stop
Start forward
Start reverse
Stop