O Extension Module 1 - ABB ACS880 Firmware Manual

No. Name/Value
13.28 AO2 source max
-32768.0 ...
32767.0
13.29 AO2 out at AO2 src
min
0.000 ... 22.000 mA Minimum AO2 output value.
13.30 AO2 out at AO2 src
max
0.000 ... 22.000 mA Maximum AO2 output value.
14
14 I/O extension
module 1
14.01 Module 1 type
None
FIO-01
FIO-11
14.02 Module 1 location
1...254
14.03 Module 1 status
No option
No communication
Unknown
FIO-01
FIO-11
14.05 DIO status
0000h...FFFFh
Description
Defines the real maximum value of the signal (selected by
parameter 13.22 AO2 source) that corresponds to the
maximum required AO2 output value (defined by parameter
13.30 AO2 out at AO2 src
source min.
Real signal value corresponding to maximum AO2 output
value.
Defines the minimum output value for analog output AO2.
See also drawing at parameter
Defines the maximum output value for analog output AO2.
See also drawing at parameter
Configuration of I/O extension module 1.
See also section Programmable I/O extensions
Note: The contents of the parameter group vary according to
the selected I/O extension module type.
Activates (and specifies the type of) I/O extension module 1.
Inactive.
FIO-01.
FIO-11.
Specifies the slot (1...3) on the control unit of the drive into
which the I/O extension module is installed.
Slot number.
Displays the status of I/O extension module 1.
No module detected in the specified slot.
A module has been detected but cannot be communicated
with.
The module type is unknown.
An FIO-01 module has been detected and is active.
An FIO-11 module has been detected and is active.
Displays the status of the digital input/outputs on the
extension module. The activation/deactivation delays (if any
are specified) are ignored.
Bit 0 indicates the status of DIO1.
Note: The number of active bits in this parameter depends on
the number of digital input/outputs on the extension module.
Example: 00001001b = DIO1 and DIO4 are on, remainder
are off.
This parameter is read-only.
Status of digital input/outputs.
max). See parameter 13.27 AO2
13.27 AO2 source
13.27 AO2 source
(page 29).
Parameters 119
Def/FbEq16
100.0
1 = 1
0.000 mA
min.
1000 = 1 mA
20.000 mA
min.
1000 = 1 mA
None
0
1
2
1 (Slot 1)
-
No option
0
1
2
3
4
-
1 = 1