ABB ACS880 Firmware Manual page 296

296 Parameters
No. Name/Value
Sequence control
FIELDBUS
96.06 Parameter restore
Done
Restore defaults
Clear all
96.07 Parameter save
manually
Done
Save
96.08 Control board boot
0...1
96.10 User set status
n/a
Loading
Saving
Faulted
User1 IO active
User2 IO active
User3 IO active
Description
Sequential control macro (see page 82).
Fieldbus control macro (see page 85).
Restores the original settings of the control program, ie.
parameter default values.
Note: This parameter cannot be changed while the drive is
running.
Restoring is completed.
All editable parameter values are restored to default values,
except
• motor data and ID run results
• control panel/PC communication settings
• I/O extension module settings
• fieldbus adapter settings
• encoder configuration data
• parameter 95.20 HW options word 1
defaults implemented by it.
All editable parameter values are restored to default values,
except
• control panel/PC communication settings
• fieldbus adapter settings
• parameter 95.20 HW options word 1
defaults implemented by it..
PC tool communication is interrupted during the restoring.
Saves the valid parameter values to permanent memory. This
parameter should be used to store values sent from a
fieldbus, or when using an external power supply to the
control board as the supply might have a very short hold-up
time when powered off.
Note: A new parameter value is saved automatically when
changed from the PC tool or control panel but not when
altered through a fieldbus adapter connection.
Save completed.
Save in progress.
Changing the value of this parameter to 1 reboots the control
unit (without requiring a power off/on cycle of the complete
drive module).
The value reverts to 0 automatically.
1 = Reboot the control unit.
Shows the status of the user parameter sets.
This parameter is read-only.
See also section User parameter sets
No user parameter sets have been saved.
A user set is being loaded.
A user set is being saved.
Invalid or empty parameter set.
User set 1 has been selected by parameters
I/O mode in1 and 96.13 User set I/O mode
User set 2 has been selected by parameters
I/O mode in1 and 96.13 User set I/O mode
User set 3 has been selected by parameters
I/O mode in1 and 96.13 User set I/O mode
and the differentiated
and the differentiated
(page 70).
96.12 User set
in2.
96.12 User set
in2.
96.12 User set
in2.
Def/FbEq16
5
6
Done
0
8
62
Done
0
1
0
1 = 1
-
0
1
2
3
4
5
6