ABB ACS880 Firmware Manual page 127

No. Name/Value
14.38 RO2 ON delay
Status of selected
source
RO status
t = 14.38 RO2 ON delay
On
t = 14.39 RO2 OFF delay
Off
0.0 ... 3000.0 s
14.39 RO2 OFF delay
0.0 ... 3000.0 s
14.41 AI2 actual value
-22.000 ... 22.000
mA or V
14.42 AI2 scaled value
-32768.000 ...
32767.000
14.43 AI2 force data
-22.000 ... 22.000
mA or V
14.44 AI2 HW switch
position
V
mA
Description
(Visible when 14.01 Module 1 type
Defines the activation delay for relay output RO2.
t t
On Off
Activation delay for RO2.
(Visible when 14.01 Module 1 type
Defines the deactivation delay for relay output RO1. See
parameter 14.35 RO1 ON
Deactivation delay for RO2.
(Visible when 14.01 Module 1 type
Displays the value of analog input AI2 in mA or V (depending
on whether the input is set to current or voltage).
This parameter is read-only.
Value of analog input AI2.
(Visible when 14.01 Module 1 type
Displays the value of analog input AI2 after scaling. See
parameter 14.50 AI2 scaled at AI2
This parameter is read-only.
Scaled value of analog input AI2.
(Visible when 14.01 Module 1 type
Forced value that can be used instead of the true reading of
the input. See parameter
Forced value of analog input AI2.
(Visible when 14.01 Module 1 type
Shows the position of the hardware current/voltage selector
on the I/O extension module.
Note: The setting of the current/voltage selector must match
the unit selection made in parameter
I/O module reboot either by cycling the power or through
parameter 96.08 Control board boot
any changes in the hardware settings.
Volts.
Milliamperes.
= FIO-01)
t
On
= FIO-01)
delay.
= FIO-11)
= FIO-11)
min.
= FIO-11)
14.22 AI force selection.
= FIO-11)
14.45 AI2 unit
is required to validate
Parameters 127
Def/FbEq16
0.0 s
1
0
1
0
Time
t
Off
10 = 1 s
0.0 s
10 = 1 s
-
1000 = 1 mA
or V
-
1 = 1
0.000 mA
1000 = 1 mA
or V
-
selection.
2
10