ABB ACS880 Firmware Manual page 147

No. Name/Value
In1P Start; In2 Stop;
In3 Dir
In1P Start fwd; In2P
Start rev; In3 Stop
Fieldbus A
D2D or M/F link
DDCS controller
Application
Program
ATF
20.07 Ext2 start trigger
type
Edge
Level
Description
The sources of the start and stop commands are selected by
parameters 20.08 Ext2 in1 source
The source selected by
direction. The state transitions of the source bits are
interpreted as follows:
State of State of
source 1 source 2
(20.08) (20.09)
0 - > 1
1
0 - > 1
1
Any 0
Notes:
• Parameter 20.07 Ext2 start trigger type
this setting.
• When source 2 is 0, the Start and Stop keys on the control
panel are disabled.
The sources of the start and stop commands are selected by
parameters 20.08 Ext2 in1
20.10 Ext2 in3 source. The source selected by
source determines the direction. The state transitions of the
source bits are interpreted as follows:
State of State of
source 1 source 2
(20.08) (20.09)
0 - > 1
Any
0 - > 1
Any
Any Any
Note: Parameter 20.07 Ext2 start trigger type
with this setting.
The start and stop commands are taken from fieldbus adapter
A.
Note: Set also 20.07 Ext2 start trigger type
The start and stop commands are taken from another drive
through the D2D (Drive-to-drive) link or the master/follower
link.
Note: Set also 20.07 Ext2 start trigger type
The start and stop commands are taken from an external
(DDCS) controller.
Note: Set also 20.07 Ext2 start trigger type
The start and stop commands are taken from the application
program control word (parameter
word).
Note: Set also 20.07 Ext2 start trigger type
Reserved.
Defines whether the start signal for external control location
EXT2 is edge-triggered or level-triggered.
Note: This parameter is not effective if a pulse-type start
signal is selected. See the descriptions of the selections of
parameter 20.06 Ext2 commands.
The start signal is edge-triggered.
The start signal is level-triggered.
and 20.09 Ext2 in2
20.10 Ext2 in3 source determines the
State of
source 3
(20.10)
0 Start forward
1 Start reverse
Any
has no effect with
source, 20.09 Ext2 in2 source
20.10 Ext2 in3
State of
source 3
(20.10)
1 Start forward
1 Start reverse
0
has no effect
to Level.
to Level.
to Level.
06.02 Application control
to Level.
Parameters 147
Def/FbEq16
5
source.
Command
Stop
6
and
Command
Stop
12
15
16
21
22
Edge
0
1