ABB ACS880 Firmware Manual page 148

148 Parameters
No. Name/Value
20.08 Ext2 in1 source
20.09 Ext2 in2 source
20.10 Ext2 in3 source
20.11 Run enable stop
mode
Coast
Ramp
Torque limit
20.12 Run enable 1
source
Off
On
DI1
DI2
DI3
DI4
DI5
DI6
DIO1
DIO2
FBA A MCW bit 3
Other [bit]
20.19 Enable start
command
Not selected
Selected
Description
Selects source 1 for parameter
For the available selections, see parameter
source.
Selects source 2 for parameter
For the available selections, see parameter
source.
Selects source 3 for parameter
For the available selections, see parameter
source.
Selects the way the motor is stopped when the run enable
signal switches off.
The source of the run enable signal is selected by parameter
20.12 Run enable 1 source.
Stop by switching off the output semiconductors of the drive.
The motor coasts to a stop.
WARNING! If a mechanical brake is used, ensure it is
safe to stop the drive by coasting.
Stop along the active deceleration ramp. See parameter
group 23 Speed reference ramp
Stop according to torque limits (parameters
Selects the source of the external run enable signal. If the run
enable signal is switched off, the drive will not start. If already
running, the drive will stop according to the setting of
parameter 20.11 Run enable stop
1 = Run enable signal on.
Note: This parameter cannot be changed while the drive is
running.
See also parameter 20.19 Enable start
0.
1.
Digital input DI1 (10.02 DI delayed
Digital input DI2 (10.02 DI delayed
Digital input DI3 (10.02 DI delayed
Digital input DI4 (10.02 DI delayed
Digital input DI5 (10.02 DI delayed
Digital input DI6 (10.02 DI delayed
Digital input/output DIO1
Digital input/output DIO2
Control word bit 3 received through fieldbus interface A.
Source selection (see Terms and abbreviations
Selects the source for the start enable signal.
1 = Start enable.
With the signal switched off, any drive start command is
inhibited. (Switching the signal off while the drive is running
will not stop the drive.)
See also parameter 20.12 Run enable 1
0.
1.
20.06 Ext2 commands.
20.03 Ext1 in1
20.06 Ext2 commands.
20.03 Ext1 in1
20.06 Ext2 commands.
20.03 Ext1 in1
on page 164.
30.19
mode.
command.
status, bit 0).
status, bit 1).
status, bit 2).
status, bit 3).
status, bit 4).
status, bit 5).
(11.02 DIO delayed status, bit 0).
(11.02 DIO delayed status, bit 1).
on page 88).
source.
Def/FbEq16
Not selected
Not selected
Not selected
Coast
0
1
and 30.20). 2
On
0
1
2
3
4
5
6
7
10
11
30
-
Selected
0
1