System - ABB ACS880 Firmware Manual

294 Parameters
No. Name/Value
95.20 HW options word 1
Bit Name
0 Supply frequency
1 Emergency stop
Cat 0
2 Emergency stop
Cat 1
3 RO2 for -07
cabinet cooling fan
4 Externally powered
control unit
5 Fuse switch
6 DOL motor switch Motor fan control (see 35.100...35.106).
7 xSFC-01 fuse
switch controller
8 Service switch
9 Output contactor
10 Brake resistor, sine
filter, IP54 fan
11...15 Reserved
0000h...FFFFh
96

96 System

96.01 Language
Not selected
English US
Deutsch
Italiano
Description
Specifies hardware-related options that require differentiated
parameter defaults. Activating a bit in this parameter makes
the necessary changes in other parameters – for example,
activating an emergency stop option reserves a digital input.
In most cases, the differentiated parameters will also be write-
protected.
This parameter, as well as the changes in other parameters
implemented by it, are not affected by a parameter restore.
Information
0 = 50 Hz
1 = 60 Hz
Emergency stop, Category 0, without FSO module.
1 = Yes. (Selects DI4 as source of emergency stop signal.)
Emergency stop, Category 1, without FSO module.
1 = Yes. (Selects DI4 as source of emergency stop signal.)
Control of cabinet cooling fan.
1 = Yes. (Reserves RO2 for fan control.)
1 = Yes. (Sets parameter
DC switch monitoring.
1 = Yes. (Sets 95.08
event 2.)
1 = Yes. (Selects RO1 for fan control, DI5 for feedback.)
1 = Yes. (Sets 95.09
Service switch connected to DI6.
1 = Yes. (Selects DI6 as source of external event 1.)
1 = Yes. (Selects RO1 for contactor control, DI5 as source of Run
enable)
Other status switches connected to the DIIL input.
1 = Yes (Selects DIIL as source of Run enable)
Hardware options configuration word.
Language selection; access levels; macro selection;
parameter save and restore; control unit reboot; user
parameter sets; unit selection.
Selects the language of the parameter interface and other
displayed information when viewed on the control panel.
Notes:
• Not all languages listed below are necessarily supported.
• This parameter does not affect the languages visible in the
Drive composer PC tool. (Those are specified under View
– Settings.)
None.
English.
German.
Italian.
95.04 to External 24V.)
to Enable and selects DIIL as source of external
to Enable.)
Def/FbEq16
-
1 = 1
-
0
1033
1031
1040