ABB ACS880 Firmware Manual page 162

162 Parameters
No. Name/Value
22.55 Critical speed 2
high
-30000.00 ...
30000.00 rpm
22.56 Critical speed 3 low
-30000.00 ...
30000.00 rpm
22.57 Critical speed 3
high
-30000.00 ...
30000.00 rpm
22.71 Motor
potentiometer
function
Disabled
Enabled (init at
power-up)
Enabled (resume at
power-up)
22.72 Motor
potentiometer initial
value
-32768.00 ...
32767.00
22.73 Motor
potentiometer up
source
Not selected
Selected
DI1
DI2
DI3
DI4
DI5
DI6
DIO1
DIO2
Other [bit]
Description
Defines the high limit for critical speed range 2.
Note: This value must be greater than or equal to the value of
22.54 Critical speed 2 low.
High limit for critical speed 2.
Defines the low limit for critical speed range 3.
Note: This value must be less than or equal to the value of
22.57 Critical speed 3 high.
Low limit for critical speed 3.
Defines the high limit for critical speed range 3.
Note: This value must be greater than or equal to the value of
22.56 Critical speed 3 low.
High limit for critical speed 3.
Activates and selects the mode of the motor potentiometer.
See section Motor potentiometer
Motor potentiometer is disabled and its value set to 0.
When enabled, the motor potentiometer first adopts the value
defined by parameter 22.72 Motor potentiometer initial
The value can then be adjusted from the up and down
sources defined by parameters
source and 22.74 Motor potentiometer down
After a power cycle, the motor potentiometer reverts to the
predefined initial value (22.72).
As Enabled (init at power-up), but the motor potentiometer
value is retained over a power cycle.
Defines an initial value (starting point) for the motor
potentiometer. See the selections of parameter
potentiometer function.
Initial value for motor potentiometer.
Selects the source of motor potentiometer up signal.
0 = No change
1 = Increase motor potentiometer value. (If both the up and
down sources are on, the potentiometer value will not
change.)
0.
1.
Digital input DI1 (10.02 DI delayed
Digital input DI2 (10.02 DI delayed
Digital input DI3 (10.02 DI delayed
Digital input DI4 (10.02 DI delayed
Digital input DI5 (10.02 DI delayed
Digital input DI6 (10.02 DI delayed
Digital input/output DIO1
Digital input/output DIO2
Source selection (see Terms and abbreviations
(page 44).
22.73 Motor potentiometer up
source.
22.71 Motor
status, bit 0).
status, bit 1).
status, bit 2).
status, bit 3).
status, bit 4).
status, bit 5).
(11.02 DIO delayed status, bit 0).
(11.02 DIO delayed status, bit 1).
on page 88).
Def/FbEq16
0.00 rpm
See par.
46.01
0.00 rpm
See par.
46.01
0.00 rpm
See par.
46.01
Disabled
0
1
value.
2
0.00
1 = 1
Not selected
0
1
2
3
4
5
6
7
10
11
-