ABB ACS880 Firmware Manual page 150

150 Parameters
No. Name/Value
DIO1
DIO2
Other [bit]
20.24 Negative speed
reference enable
20.25 Jogging enable
Not selected
Selected
DI1
DI2
DI3
DI4
DI5
DI6
DIO1
DIO2
Other [bit]
20.26 Jogging 1 start
source
Not selected
Selected
DI1
DI2
DI3
DI4
DI5
DI6
DIO1
Description
Digital input/output DIO1
Digital input/output DIO2
Source selection (see Terms and abbreviations
Selects the source of the negative speed reference enable
command. See parameter
enable.
Selects the source for a jog enable signal.
(The sources for jogging activation signals are selected by
parameters 20.26 Jogging 1 start source
start source.)
1 = Jogging is enabled.
0 = Jogging is disabled.
Note: Jogging can be enabled only when no start command
from an external control location is active. On the other hand,
if jogging is already enabled, the drive cannot be started from
an external control location (apart from inching commands
through fieldbus).
See section Jogging (page 41).
0.
1.
Digital input DI1 (10.02 DI delayed
Digital input DI2 (10.02 DI delayed
Digital input DI3 (10.02 DI delayed
Digital input DI4 (10.02 DI delayed
Digital input DI5 (10.02 DI delayed
Digital input DI6 (10.02 DI delayed
Digital input/output DIO1
Digital input/output DIO2
Source selection (see Terms and abbreviations
If enabled by parameter
source for the activation of jogging function 1. (Jogging
function 1 can also be activated through fieldbus regardless
of parameter 20.25.)
1 = Jogging 1 active.
Notes:
• If both jogging 1 and 2 are activated, the one that was
activated first has priority.
• This parameter cannot be changed while the drive is
running.
0.
1.
Digital input DI1 (10.02 DI delayed
Digital input DI2 (10.02 DI delayed
Digital input DI3 (10.02 DI delayed
Digital input DI4 (10.02 DI delayed
Digital input DI5 (10.02 DI delayed
Digital input DI6 (10.02 DI delayed
Digital input/output DIO1
(11.02 DIO delayed status, bit 0).
(11.02 DIO delayed status, bit 1).
on page 88).
20.23 Positive speed reference
and 20.27 Jogging 2
status, bit 0).
status, bit 1).
status, bit 2).
status, bit 3).
status, bit 4).
status, bit 5).
(11.02 DIO delayed status, bit 0).
(11.02 DIO delayed status, bit 1).
on page 88).
20.25 Jogging enable, selects the
status, bit 0).
status, bit 1).
status, bit 2).
status, bit 3).
status, bit 4).
status, bit 5).
(11.02 DIO delayed status, bit 0).
Def/FbEq16
10
11
-
Selected
Not selected
0
1
2
3
4
5
6
7
10
11
-
Not selected
0
1
2
3
4
5
6
7
10