ABB ACS880 Firmware Manual page 284

284 Parameters
No. Name/Value
91.06 Module 2
temperature
0...1000 °C or °F
91.10 Encoder parameter
refresh
Done
Configure
91.11 Module 1 type
None
FEN-01
FEN-11
FEN-21
FEN-31
91.12 Module 1 location
Slot 1
Slot 2
Slot 3
4...254
91.13 Module 2 type
None
FEN-01
FEN-11
FEN-21
FEN-31
91.14 Module 2 location
Slot 1
Slot 2
Slot 3
4...254
91.21 Temperature meas
sel1
None
PTC
KTY-84
91.22 Temperature
filtering time 1
0...10000 ms
Description
Displays the temperature measured through the sensor input
of interface module 2. The unit is selected by parameter
96.16 Unit selection.
This parameter is read-only.
Temperature measured through interface module 2.
Forces a reconfiguration of the FEN-xx encoder interface
modules, which is needed for any parameter changes in
groups 90...93 to take effect.
Note: The parameter cannot be changed while the drive is
running.
Reconfiguration done (normal operation).
Reconfigure. The value reverts automatically to Done.
Defines the type of the module used as interface module 1.
None (communication disabled).
FEN-01.
FEN-11.
FEN-21.
FEN-31.
Specifies the slot (1...3) on the control unit of the drive into
which the interface module is installed.
Slot 1.
Slot 2.
Slot 3.
Reserved.
Defines the type of the module used as interface module 2.
None (communication disabled).
FEN-01.
FEN-11.
FEN-21.
FEN-31.
Specifies the slot (1...3) on the control unit of the drive into
which the interface module is installed.
Slot 1.
Slot 2.
Slot 3.
Reserved.
Specifies the type of temperature sensor connected to
interface module 1.
None.
PTC.
KTY84.
Defines a filtering time for the temperature measurement
through interface module 1.
Filtering time for temperature measurement.
Def/FbEq16
-
-
Done
0
1
None
0
1
2
3
4
Slot 1
1
2
3
1 = 1
None
0
1
2
3
4
Slot 1
1
2
3
1 = 1
None
0
1
2
1500 ms
-