Dimensions; 6-2-10 Mounting In Control Panels - Omron DeviceNet CV Series Operation Manual

RS-232C Units
6-2-9

Dimensions

6-2-10 Mounting in Control Panels

Using Screws
Using DIN Track
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
Mounting holes
Two, 4.2 dia. or M4
Either of the following methods can be used to mount an RS-232C Unit in a
control panel.
Drill mounting holes in the control panel according to the dimensions provided
for mounting holes in the dimensions diagrams and then secure the RS-232C
Unit with M4 screws. The appropriate tightening torque is 0.6 to 0.98 N ⋅ m.
Mount the back of the RS-232C Unit to a 35-mm DIN Track. To mount the
Unit, pull down on the mounting hook on the back of the Unit with a screw-
driver, insert the DIN Track on the back of the Unit, and then secure the Unit
to the DIN Track. When finished, secure all Slaves on both ends of the DIN
Track with End Plates.
Section 6-2
Unit: mm
285