Omron DeviceNet CV Series Operation Manual page 231

Waterproof Terminals (IP67)
Note
I/O Wiring
Note
214
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
Compatible Connectors
Connector
Cable with connectors on both ends (socket and plug)
Cable with connector on one end (female socket)
Connector socket assembly (female)
(Crimp-connector or solder type)
T-joint
DRT1-ID04CL
XS2R-D427-5
T-joint
XS2F-D42@-@80-@ Cable with
shielded socket on one end
1. Tighten the connector by hand to a torque of 0.39 to 0.49 N ⋅ m. If the con-
nector is not tightened sufficiently, it will not provide the expected environ-
mental resistance and may come loose from vibration. Do not use pliers or
other tools to tighten the connectors, because the tools may damage the
connectors.
2. The same I/O power supply can be used for both input and output devices,
but the noise from the output devices may cause the input devices to mal-
function. Use separate power supplies if possible.
Connect the I/O Wiring to the Environment-resistive Terminal with the XS2-
series Round Waterproof Connectors listed in the following table.
Compatible Connectors
Connector
Cable with connector on one end (male plug)
Cable with connectors on both ends (socket and plug)
Connector plug assembly (male)
(Crimp-connector or solder type)
Sensors that are pre-wired with a connector can be connected directly.
Refer to the Catalog or manual for details on the device's connections before
connecting any device.
XS2W-D42@-@81-A Cable
with shielded socket on one
end and plug on the other
Sensor with attached connector
Pre-wired Sensor with connector
1. Refer to the OMRON Sensors Catalog (X42-E1-3) for more details on the
sensor connections and Round Waterproof Connectors.
2. Tighten the connector by hand to a torque of 0.39 to 0.49 N ⋅ m. If the con-
nector is not tightened sufficiently, it will not provide the expected environ-
XS2W-D42@-@81-@
XS2F-D42@-@80-@
XS2C-D4@@
CS2R-D427-5
DRT1-OD04CL
I/O power supply
I/O power supply
XS2W-D42@-@81-@
Cables with shielded
socket on one end
and plug on the other
XS2R-D427-5
T-joint
XS2W-D42@-@81-@ Cable
with shielded socket on one
end and plug on the other
Model number
XS2H-D421-@80-A
XS2W-D42@-@81-A
XS2G-D4@@
XS2H-D421-@80-A Cable with
shielded plug on one end
XS2G-D4@@
Pre-wired Sensor
Section 5-4
Model