Table of Contents
Advertisement
Operating notes
All summary data and GPS data is stored at the task
level. To make this information more usable:
• Only one tag may be assigned to a task. When a differ-
ent tag is required during the current work, the operator
must create a new task. Change the task first, and then
change the tag.
• Only one operator may be assigned to a task. When a
different operator takes over the current work, the oper-
ator must create a new task. Change the task first, and
then change the operator.
• Only one operation may be assigned to a task. When a
new operation is selected for the same field, the oper-
ator must create a new task. Change the task first, and
then change the operation.
• Only one vehicle may be assigned to a task. Tasks
cannot be shared between vehicles.
• Only one implement may be assigned to a task. If a new
implement takes over the current operation in the same
field, the operator must create a new task. Change the
task first, and then change the implement.
• Only one work condition may be assigned to a task.
If a new or a modified work condition is needed, the
operator must create a new task. Change the task first,
and then change the work condition.
Press the "Task" window to access the pop-up options
window.
If no tasks are available, the only option is "New."
Thereafter, the options are "Select," "Edit Name," or
"New."
Press "Select" to choose a task from the current list.
Press "Edit Name" to change the name of a task.
Press "New" to add a task to the current list.
Press the desired option.
If "Select" is pressed, a pop-up options window of current
tasks displays.
NOTE: The options window may contain entries in italics.
These entries are not selectable because they were cre-
ated by a different vehicle, by a different application, or by
a different sensor during crop calibration.
Press the required task.
The screen updates with the selected task.
3 - SETUP
3-10
22
RCIL11DSP208BBG
23
RCIL11DSP210BBG
Advertisement
Table of Contents
