Case IH AFS Pro 700 Software Operating Manual page 161

Use the "Converge Distance" window with RTX™ correc-
tion signal to reduce the convergence time associated
with this technology. The setting in this window affects
the signal accuracy required for initial convergence: the
system continues to converge to the full signal accuracy
of RTX™ technology, but the system becomes available
for use earlier.
Converge distance is the distance that RangePoint™
RTX™ uses to establish the location of a point while
converging. The system default is 0.102 m (4.0 in).
Increasing the distance allows the system to be ready for
use earlier, but with less accuracy.
If the planned work does not require the highest level of
accuracy, increase the converge distance so that the sys-
tem will be available for use earlier. If the planned work
does require great accuracy, set the "Converge Distance"
window to the default value of 0.102 m (4 in). In both
cases, the system will ultimately converge to the full ac-
curacy of RangePoint™ RTX™ technology.
NOTE: Do not confuse the converge distance with the
accuracy of the technology.
Press the "Converge Distance" window to access the nu-
meric keypad.
Use the keypad to enter a new converge distance. Ac-
ceptable values are 0.1 - 1 m (4 - 39 in).
Press the "Enter" button on the keypad to save the value.
3 - SETUP
3-79
4
RAIL14DSP1572BA
5
RAIL14DSP1574BA