Table of Contents
Advertisement
2. Drive the vehicle to the start of the course and press
the "Start" button. The vehicle can be moving or sta-
tionary when the "Start" button is pressed.
NOTE: Careful alignment with the start position is crit-
ical for the most accurate results.
When the "Start" button is pressed, the accumulating
distance, as measured by radar, displays in the "Mea-
sured Distance" window.
3. Drive to the end of the course at the intended work-
ing speed and press the "Stop" button. The vehicle
can be moving or stationary when the "Stop" button is
pressed.
NOTE: Careful alignment with the stop position is crit-
ical for the most accurate results.
When the "Stop" button is pressed, the "Measured Dis-
tance" window stops accumulating distance.
4. Enter the actual length of the course as it was mea-
sured by tape measure.
Press the "Actual Distance" window to access the nu-
meric keypad.
Use the keypad to enter the value in meters or feet,
depending on the unit of measurement selected.
Press the "Enter" button on the keypad to save the
value.
3 - SETUP
3-26
13
RCIL11DSP388BBG
14
RCIL11DSP389BBG
15
RCIL11DSP390BBG
Advertisement
Table of Contents
