Multiple Vehicle Practices - Case IH AFS Pro 700 Software Operating Manual

Multiple vehicle practices

If you have more than one vehicle of the same type (trac-
tor, combine, etc.) with an AFS pro 700 display, label each
memory stick with the product identification number (PIN)
or serial number of the vehicle. Always match the mem-
ory stick to the vehicle when it is used.
1. Use a single vehicle or the desktop software to create
any of these data types:
• grower
• farm
• field
• tags
• operator
• product
• field mark
• boundary
• obstacle
• swath
If required, transfer the memory stick from the desktop
computer to a vehicle.
2. Create any "Run" screen layouts with a single vehicle.
On tractors, create implements and sequences. On
combines, perform crop setup.
3. Once setup is complete on the memory stick, power
OFF the display and remove the device from the vehi-
cle.
4. Install the memory stick from the first vehicle in the
next vehicle.
5. Power ON the display to automatically share the
grower/farm/field, etc. from the device with the dis-
play.
6. Use the "Import" screen (Home > Data Management >
Import) to add the other data types: crop setup, "Run"
screen layouts, implements, work conditions, etc.
NOTE: When a field is created, a new task is automatically
created. Delete these tasks from the memory stick for the
first vehicle before sharing the grower/farm/field informa-
tion with other vehicles. These tasks cannot be used by
the second vehicle. They appear in italics on option lists
and cannot be selected.
7. Repeat steps 3-6 for each additional vehicle.
8. After sharing the memory stick with each vehicle,
power ON the display with the device that is matched
to that vehicle (not the first vehicle). Verify that all of
the information has successfully transferred.
9. At the end of the day, archive the information from the
memory stick for each vehicle to your desktop com-
puter.
4 - OPERATION
4-36
1
RCIL11DSP171BBG