Table of Contents
Advertisement
Radar calibration - generic tractor
On the "Home" screen, press the "Calibration" icon to ac-
cess the "Calibration" screens.
Press the "Radar" icon in the navigation bar to display the
"Radar Cal" screen.
NOTE: The "Radar Cal" screen is not available if radar is
not enabled on the "Vehicle" screen (Home > Toolbox >
Vehicle).
To perform radar calibration:
1. Measure a course with a distance of at least 121.9 m
(400 ft) and place a marker at the beginning and end
of the measured course.
A 121.9 m (400 ft) course is shown in this procedure.
This procedure shows metric measurement. If U.S.
Standard units were selected, screen values will be in
feet.
NOTE: When determining course length, a measuring
tape is preferred over a measuring wheel because a
measuring tape provides greater accuracy.
3 - SETUP
3-22
1
RCIL11DSP108BBG
2
RCIL11DSP378BBG
3
RCIL11DSP378BBG
Advertisement
Table of Contents
