Table of Contents
Advertisement
"Run" screen windows for the Virtual Terminal (VT)
Up to seven additional "Run" screen windows are
available whenever the "Virtual Terminal" application is
present:
• "VT 2x6"
• "VT Auxiliary Memory"
• "VT Implements 1x1"
• "VT Implements 1x2"
• "VT NV Memory"
• "VT RAM Memory"
• "VT Upload"
The windows are primarily intended for developers to test
the compatibility of their software with the "Virtual Termi-
nal" application. Select the windows for a "Run" screen
using the "Run Layout" screen (Home > Toolbox > Lay-
out).
"VT 2x6"
Placement label: VT 2x6
Placement location: "Run" screens
Rather than use the "Home" screen as a pivot point
between the "Virtual Terminal" screens and the "Run"
screens, you can place the "VT 2x6" window on any
"Run" screen to make navigation quicker. This window
has a two column by six row layout and uses the total
area of the selected "Run" screen.
NOTE: If required, change the layout of the selected "Run"
screen to a 2 column by 6 row layout before you place the
"VT 2x6" window.
The operation of the ISOBUS application is the same
whether you access it with the "VT" screen (Home > VT_
or with the "VT 2x6" window the on the "Run" screens.
Only the content of the bottom navigation bar differs.
"VT Auxiliary Memory"
Placement label: VT Aux Mem.
Placement location: "Run" screens or left-hand area
A bar graph visually represents the use of auxiliary mem-
ory by all active implement or tool applications.
NOTE: This window is only available when the "VT Com-
patibility" window on the "VT Setups" screen (Home >
Toolbox > VT > Setup) is set to "Version 2."
6 - VIRTUAL TERMINAL (VT) OR UNIVERSAL TERMINAL (UT)
6-21
1
RAIL14DSP1397BA
2
RAIL14DSP1436BA
3
RAIL14DSP1399BA
Advertisement
Table of Contents
