Case IH AFS Pro 700 Software Operating Manual page 145

If you selected "RTX/Sat-Std" or "RTX/Sat-Fast," the "RTX
Setup" window displays.
Press the "Edit" button in the "RTX Setup" window to ac-
cess the pop-up "RTX Setup" window.
Use the "RTX Satellite Frequency" window and the "RTX
Baud Rate" window to select the correct satellite fre-
quency and baud rate for your region. Refer to the below
table:
Region
Western North 1557.8615 MHz
America
Central North 1557.8150 MHz
America
Eastern North 1557.8590 MHz
America
South/Central 1539.8325 MHz
America
Europe/Africa 1539.9525 MHz
1539.8325 MHz
Asia Pacific
Press the "OK" button to save the entered information to
the display's memory.
Use the "Converge Distance" window with RTX™ correc-
tion signal to reduce the convergence time associated
with this technology. The setting in this window affects
the signal accuracy required for initial convergence: the
system continues to converge to the full signal accuracy
of RTX™ technology, but the system becomes available
for use earlier.
Converge distance is the distance that CenterPoint™
RTX™ uses to establish the location of a point while
converging. The system default is 0.102 m (4.0 in).
Increasing the distance allows the system to be ready for
use earlier, but with less accuracy.
If the planned work does not require the highest level of
accuracy, increase the converge distance so that the sys-
tem will be available for use earlier. If the planned work
does require great accuracy, set the "Converge Distance"
window to the default value of 0.102 m (4 in). In both
cases, the system will ultimately converge to the full ac-
curacy of CenterPoint™ RTX™ technology.
NOTE: Do not confuse the converge distance with the
accuracy of the technology.
Satellite Baud rate
frequency
600 Bd
2400 Bd
600 Bd
600 Bd
600 Bd
600 Bd
3 - SETUP
3-63
4
RAIL14DSP1561BA
5
RAIL14DSP1562BA
6
RAIL14DSP1561BA