Table of Contents
Advertisement
The base station has an Autobase function which allows
it to determine the GPS coordinates for the receiver's
current position. Once it determines its GPS location, it
stores that information in the base station.
Each time the base station is moved to a new location,
Autobase is used to save the GPS coordinates for that
position.
When the base station is returned to a previously saved
position, it searches its library for stored locations and
loads the correct coordinate file. Autobase is no longer
required for known locations.
At each new location, the operator must provide the base
station with the correct GPS antenna height before Auto-
base can be used. Measure antenna height (h) from the
ground to the base of the GPS antenna. Enter the value
with the keypad on the base station.
Refer to the base station operator's manual for additional
information.
When you select "AgGPS Radio" in the "Correction
Level" window, the screen updates with additional
windows for radio-based RTK correction:
• "Channel ID"
• "RTK Security"
• "xFill Mode"
Press the "Channel ID " window to access the numeric
keypad.
NOTE: The base station operator should provide you with
the current channel ID for the base station.
Use the keypad to enter the correct ID number.
Press the "Enter" button on the keypad to save the setting.
3 - SETUP
3-50
6
RCPH11DSP018BAG
7
RAIL14DSP1526BA
8
RAIL14DSP1527BA
Advertisement
Table of Contents
