Real Time Kinematic (Rtk) Setup - Case IH AFS Pro 700 Software Operating Manual

Real Time Kinematic (RTK) setup

There are two possible sources for RTK signal on a vehicle:
• Radio (AgGPS®): receives signal from a data radio at a local base station
• Modem (DCM-300 or Ag3000™): receives signal from a wireless General Packet Radio Service (GPRS) connec-
tion via a network of municipally or privately owned reference stations
Use the "Correction Type" window to select the correction
technology that you intend to use.
Press the "Correction Type" window to display the pop-up
options window.
NOTE: The pop-up options window only includes the
types of correction that have been activated for your
receiver.
Press "RTK" in the options window.
A pop-up message displays: "Correction level indicates
the source being used to receive the DGPS correction
signal. Press OK to close this pop up and to use the
Correction Level window."
Press the "OK" button to acknowledge the message.
Use the "Correction Level" window to establish how
the vehicle will receive the RTK correction signal. The
possible options are:
• "AgGPS Radio"
• "DCM-300/Ag3000"
Press the "Correction Level" window to access the pop-up
options window.
Press the correct option for your configuration.
Each configuration has unique setup requirements that are described below.
Information about the windows that are common to both configurations – "xFill Mode," "xFill Setup," and "Scintillation
Mode" – is at the end of this section.
3 - SETUP
3-47
1
RAIL14DSP1523BA
2
RAIL14DSP1524BA
3
RAIL14DSP1525BA