Table of Contents
Advertisement
• If the vehicle was NOT moved, press the "No." button.
Convergence will occur with the time saving of position
recall.
An icon flashes in the status and warning
icon area to remind the operator that the
vehicle must not be moved.
NOTE: If you accidentally answer the question incorrectly,
reset the convergence process with the "RTX Conver-
gence" window on the "GPS Status" screen (Home > Di-
agnostics > GPS).
When the initialization process is complete, another mes-
sage displays: "You may now move the vehicle."
This message does NOT mean that the signal is con-
verged, but rather that you can move the vehicle without
interrupting the ongoing signal convergence.
Press the "OK" button to acknowledge and clear the mes-
sage.
If position recall fails, the system automatically restarts the
convergence process.
Use the "Reset" button in the "RTX Convergence"
window on the "GPS Status" screen to manually reset
the position calculation if:
You answered "No" at the initial recall message, but
then discover that the vehicle was moved
OR
• The "DGPS Convergence" bar graph window on the
"GPS Status" screen (Home > Diagnostics > GPS) does
not indicate any progress for 10 - 20 min
NOTE: If the bar graph in the "RTX Convergence" window
is progressing toward 100 %, do not reset the process. If
the bar graph is stopped at a low percentage, reset the
process.
3 - SETUP
3-66
13
RAIL14DSP1566BA
14
RAIL14DSP1568BA
15
RAIL14DSP1569BA
Advertisement
Table of Contents
