Case IH AFS Pro 700 Software Operating Manual page 311

"Send ISO Speed?"
Use the "Send ISO Speed?" window to establish whether
the display will send ground speed information to the
ISOBUS implement.
This setting depends on the ISOBUS implement and
your operating conditions:
• If your ISOBUS implement is equipped with a wheel
speed sensor, leave this window set to "No."
• If your tractor is equipped with a Tractor Electronic Con-
trol Unit (TECU), leave this window set to "No."
Press the "Send ISO Speed" window to access the pop-up
options window.
Press the desired option.
NOTE: The available options depend on your vehicle con-
figuration.
"VT Number"
Use the "VT Number" window to establish whether more
than one UT is in use. Because the ISO 11783 standard
allows more than one UT to operate simultaneously, you
must identify which UT the "Virtual Terminal" application
is.
You should leave this window set to "1" if:
• you are operating with the "Virtual Terminal" application
as your only UT
OR
• you wish to map the ISOBUS implement functions to
controls on an ISOBUS auxiliary input device
NOTE: The "Auxiliary Controls" screen is only available
for the first UT (number 1). If the "VT Number" window
is set to a value other than "1," the "AUX" icon in the
navigation bar is inactive and you cannot select it.
Press the "VT Number" window to access the numeric
keypad.
6 - VIRTUAL TERMINAL (VT) OR UNIVERSAL TERMINAL (UT)
6-5
10
RAIL14DSP1363BA
11
RAIL14DSP1367BA
12
RAIL14DSP1363BA