Case IH AFS Pro 700 Software Operating Manual page 11

Power ON and power OFF
When the ignition switch is turned ON, the display loads
its startup page.
The Light Emitting Diode (LED) on the front of the display
should be green, indicating that the display is both pro-
grammed and powered ON.
If the LED is not lit, check the harness connector to the
display. Then check the cab power fuses for the display.
To function properly, the display requires switched power,
unswitched power, and ground.
If the LED is lit, but is not green, contact your Case IH
dealer for assistance.
When the ignition switch is turned OFF, there is a short
delay before the screen goes blank. During this delay,
the display uses unswitched power to save the current
settings and to close all files in display memory or on the
memory stick.
The screen displays a message: "Your data is being
saved. Please do not turn off battery key while display is
shutting down." Data loss may occur if the memory stick
is removed before all files are properly closed.
The display sounds three short beeps when the process
is complete.
The absence of the short beeps may indicate that
unswitched power to the display is not present. Absence
of unswitched power can result in the loss or corruption
of information on the memory stick.
Check the cab unswitched power fuses for the display, or
contact your Case IH dealer for assistance. This problem
must be resolved for the display to function properly.
1 - GENERAL
1-7
8
RAIL12DSP1369BA
9
RAIL15DSP0026BA