Table of Contents
Advertisement
Swath alignment
The swath map can reveal problems with swath
alignment as in this example where the vehicle offset
values were not entered correctly. A pattern of overlap
in one pass, followed by skip in the next pass, indicates
that the implement or header was not set up properly.
This may occur if:
• The implement or header is offset on the vehicle, but no
offset value was entered.
• The wrong value was entered for the offset amount.
OR
• The wrong direction was entered for the offset: a pos-
itive value was used for the offset amount instead of a
negative value, or vice versa.
The swath map can also reveal problems with the
implement width or header width definition.
• If the same value is entered for swath width (or working
width) and implement width (or header width), a skip is
present between each pass.
• If the values for implement width (or header width) and
swath width (or working width) are switched, each pass
overlaps the previous pass.
3 - SETUP
3-167
14
RAIL12DSP1004BA
15
RAIL12DSP1005BA
16
RAIL12DSP1006BA
Advertisement
Table of Contents
