Table of Contents
Advertisement
A pop-up message displays: "Auxiliary Control Mappings
for selected implement will be saved. Proceed?"
Press the "Yes" button to save the new auxiliary control
mappings.
Press the "No" button to clear the new auxiliary control
mappings..
After you press the "Yes" button, the controls that you
mapped – joystick buttons in this example – will control
the functions of the ISOBUS implement or tool.
The settings reside in Non-Volatile Memory (NVM) and
persist – even over power cycles – until an operator edits
them or deletes them.
NOTE: If you replace the display or perform a clean install
of the display software without retaining your data, you
must perform auxiliary control mapping again.
If you wish to discontinue use of the ISOBUS implement or
tool for any reason, you can press the "Delete" button on
the "Auxiliary Controls" screen to clear the auxiliary control
mappings.
A pop-up message displays: "Auxiliary Control Mappings
for selected implement will be deleted. Proceed?"
Press the "Yes" button to clear the auxiliary control map-
pings.
Press the "No" button to keep the current auxiliary control
mappings.
6 - VIRTUAL TERMINAL (VT) OR UNIVERSAL TERMINAL (UT)
6-14
13
RAIL14DSP1420BA
14
RAIL14DSP1419BA
15
RAIL14DSP1421BA
Advertisement
Table of Contents
