Case IH AFS Pro 700 Software Operating Manual page 105

2. Enter the actual length of the course as it was mea-
sured by tape measure.
Press the "Distance" window to access the numeric key-
pad.
Use the keypad to enter the value in meters (feet).
Press the "Enter" button on the keypad to save the
value.
3. Drive to the start of the course and press the "Start"
button. The vehicle can be moving or stationary when
the "Start" button is pressed.
NOTE: Careful alignment with the start position is crit-
ical for the most accurate results.
A "Stop" button appears, and the "Radar"
icon flashes in the status and warning
icon area. The icon indicates that radar
calibration is in progress.
4. Drive to the end of the course at the intended work-
ing speed and press the "Stop" button. The vehicle
can be moving or stationary when the "Stop" button is
pressed.
NOTE: Careful alignment with the stop position is crit-
ical for the most accurate results.
When the "Stop" button is pressed, the "Radar Mea-
sured" window displays the length of the course as it
was measured by radar. The flashing icon disappears
from the status and warning icon area.
3 - SETUP
3-23
4
RCIL11DSP379BBG
5
RCIL11DSP380BBG
6
RCIL11DSP382BBG