Table of Contents
Advertisement
"Write to Card"
NOTE: The "Write to Card" window is only visible when
the "GPS Location" window is set to "Not Installed" and
the "Interface Level" window (Home > Toolbox > Disp) is
set to "Advanced."
NOTE: This functionality is retained for some combines.
The combine must be equipped with ground speed,
header height, and crop sensors to use this option.
Press the down arrow on the scroll bar to view the second
"GPS Setup" screen.
The "Write to Card" window is available when farming soft-
ware supports data logging, but no GPS receiver is in-
stalled on the vehicle. Input from crop sensors and area
counters is recorded directly to the internal memory of the
display, but is not mapped.
When the "Write to Card" window is set to "No," the system
does not check for the presence of the memory stick. Op-
erational summary data is logged to internal display mem-
ory only.
When the "Write to Card" window is set to "Yes," the sys-
tem does check for the presence of the memory stick.
Operational summary data is logged to the memory stick
when supported by the vehicle software.
When the system is configured for GPS, the "Write to
Card" window is automatically set to "Yes." The window is
not available since all GPS data is recorded to the mem-
ory stick.
Press the down arrow on the scroll bar to access the sec-
ond "GPS Setup" screen.
Press the "Write to Card" window to display the options
window.
Press "Yes" to enable the option.
Press the "Close"
button to exit the window without
changing the setting.
3 - SETUP
3-37
3
RAIL14DSP1501BA
4
RAIL14DSP1502BA
Advertisement
Table of Contents
