If position recall fails, the system automatically restarts the
convergence process.
Use the "Reset" button in the "HP/XP Convergence"
window on the "GPS Status" screen to manually reset
the position calculation if:
You answered "No" at the initial recall message, but
then discover that the vehicle was moved
OR
• The "HP/XP Convergence" bar graph window on the
"GPS Status" screen (Home > Diagnostics > GPS) does
not indicate any progress for 10 - 20 min
NOTE: If the bar graph in the "HP/XP Convergence"
window is progressing toward 100 %, do not reset the
process. If the bar graph is stopped at a low percentage,
reset the process.
Go to the "GPS Status" screen (Home > Diagnostics >
GPS) to reset the convergence process.
Press the "Reset" button to restart the convergence
process.
3 - SETUP
3-77
26
RAIL14DSP1587BA
27
RAIL14DSP1590BA