Table of Contents
Advertisement
The default boundary name is "Boundary XX" where "XX"
is a number that increments each time another boundary
is created in the current field.
If desired, type a new name for the boundary.
Press the "Enter" button to save the name.
Press the "Close" button to exit without saving.
The operator must indicate a horizontal position (based
on the implement width or header width) that should be
used to record the boundary: left (1), center (2) or right
(3).
3 - SETUP
3-113
5
RCIL11DSP053BBG
6
RCIL11DSP028BBG
7
RCIL11DSP027BBG
Advertisement
Table of Contents
