Table of Contents
Advertisement
Once any window on the "Weather Notes" screen is popu-
lated, the "Time Observed" window becomes active. The
current time and date automatically appear.
The time and date values displayed are from the windows
on the "Display Setup" screen for this moment of obser-
vation.
The time stamp uses the format selected in the "Time
Format" window on the "Operator Setup" screen (Home
> Toolbox > Oper). The date stamp uses the format se-
lected in the "Date Format" window on the same screen.
Thereafter, at any time, the operator can update the time
and date stamp for the moment of observation by pressing
the "Time Observed" window.
An information message displays: "Select Update if you
wish to update the Time Observed to the current time.
Cancel will cancel any update to Time Observed."
Press the "Update" button on the message to update the
"Time Observed" value to the current time and date and
clear the message.
Press the "Cancel" button to leave the current time and
date stamp unchanged and clear the message.
Press the "Wind Speed" window to access the numeric
keypad.
Use the keypad to enter the current wind speed in dec-
imal increments in km/h or mph, depending on the unit
of measurement selected. The acceptable range is 0.0 -
160.9 km/h (0.0 - 100.0 mph).
Press the "Enter" button on the keypad to save the value.
NOTE: To change this value, the operator must access
the keypad, delete the current value, and enter a new one.
3 - SETUP
3-173
4
RCIL11DSP432BBG
5
RCIL11DSP433BBG
6
RCIL11DSP435BBG
Advertisement
Table of Contents
