Table of Contents
Advertisement
"Telematics CAN Node"
Use the "Telematics CAN Node" window to set the CAN
channel that the modem is connected to.
The default setting for this window is "CAN A."
Press the "Telematics CAN Node" window to access the
pop-up options window.
The below table lists the correct setting by vehicle type.
Vehicle type
Tractor
Sprayer
Combine
Cane Harvester
Press the correct setting for your vehicle in the options
window.
"File Transfer Enabled" ( AM53 modem only)
The AM53 modem adds the ability to connect to the AFS
Connect server and upload the data from your display.
Because the volume of data is too large for communica-
tion over the CAN, the display transfers the data to the
modem via a serial cable connected to one of the two
RS-232 ports on the display. To enable the file transfer
feature, you must identify which RS-232 port the modem
is connected to.
Press the "File Transfer Enabled" window to access the
pop-up options window.
7 - "TELEMATICS" APPLICATION
CAN node
CAN A
CAN B
CAN A
CAN B
7-4
10
RAIL14DSP1624BA
11
RAIL14DSP1625BA
12
RAIL14DSP1624BA
Advertisement
Table of Contents
