Case IH AFS Pro 700 Software Operating Manual page 107

Distance calibration - generic harvester
(combine, cotton picker)
On the "Home" screen, press the "Calibrations" icon to
access the "Calibration" screens.
Press the "Distance" icon in the navigation bar to display
the "Distance Calibration" screen.
To perform distance calibration:
1. Measure a course with a distance of at least 121.9 m
(400 ft) and place a marker at the beginning and end
of the measured course.
A 121.9 m (400 ft) course is shown in this procedure.
This procedure shows metric measurement. If U.S.
Standard units were selected, screen values would be
in feet.
NOTE: When determining course length, a measuring
tape is preferred over a measuring wheel because a
measuring tape provides greater accuracy.
3 - SETUP
3-25
10
RAIL12DSP1031BA
11
RCIL11DSP388BBG
12
RCIL11DSP388BBG