Table of Contents
Advertisement
Setup Paper Trays
Note
If A4 stock is to be loaded in tray 2, service must be called to adjust the guide level.
To enable a tray
1. Right-click one of the trays in the Paper Trays window.
2. Click Enable Tray from the Tray pull-down menu.
To disable a tray
If a tray is broken, in need of service, or you do not want it used for some reason, you can disable it.
1. Right-click one of the trays in the Paper Trays window.
2. Click Disable Tray from the Tray pull-down menu.
About Auto Tray Switching and setting tray priorities
The Xerox Nuvera is designed to allow a job to be submitted using only job attributes, and the system
will then, based upon tray priorities, pull stock from the tray(s) containing the programmed stock.
You have the ability to control the order in which trays are used by the system, by setting each tray's
priorities. For example, if trays 1 and 2 contain the same type of paper, but you are running a big job,
you can set tray 2 to be chosen first, since it has a larger paper capacity. In this case, the job pulls stock
from tray 2 first. When tray 2 is out of stock, the job switches to pull from tray 1. Once tray 2 is refilled,
the job switches back to pulling stock from tray 2.
Feed Until Empty
A user selected workflow, Feed Until Empty, tells the system to empty the second tray before switching
back to the original tray. In the above example, once tray 2 is empty, the job switches to pulling stock
from tray 1 and remains pulling stock from that tray until it is empty. Once tray 1 is empty, the job
immediately switches back to tray 2, if it has be refilled.
To Select Feed Until Empty
To enable Feed Until Empty:
1. Select System > User Diagnostics > Feed System Optimization Customer Setup > Feed Until
Empty Algorithm.
Note
To find out at a glance the priority setting of each paper tray, scroll to the right side of the Paper Trays
table. The Priority column shows the current setting for each tray.
To set tray priority
1. On the Home Screen, click Paper Trays and double-click the paper tray you want to set.
2. On the Tray Properties window, click the Options button.
3. In the Tray Priority text box, type a lower number (the lower the number, the higher the tray priority).
4. Repeat Steps 2-4 to check that the other trays are assigned priority numbers which will cause the
system to use them in the order you want.
5. When satisfied with the priority settings on each Tray Properties window, click OK.
11-4
Xerox
®
Nuvera
®
User Guide and Training Aid (UGTA)
Advertisement
Table of Contents
