Skoda Octavia III 2013 Workshop Manual page 103

Test timing:
– Turn the crankshaft in direction of rotation of engine by 2 turns.
– Turn the fixing screw - T10340- up to the stop in the cylinder
block and tighten to 30 Nm.
– Turn the crankshaft further in direction of rotation of engine to
the stop.
• The crankshaft sprocket now lies on the fixing screw and the
"TCD" position is set.
Note
The crankshaft is only locked in direction of rotation of engine
using the fixing screw - T10340- .
Note
The camshaft clamp -T10494- must move into position easily.
♦
The camshaft clamp must not be positioned using any kind of
♦
hammer.
– Insert camshaft control -T10494- to stop into camshafts and
tighten screw -arrow- hand-tight.
If camshaft clamp - T10494- cannot be installed:
– Using the assembly tool - T10487- in -direction of arrow- press
on the toothed belt.
– While doing so, insert camshaft control -T10494- to stop into
camshafts and tighten screw hand-tight.
If it is not possible to insert the camshaft clamp -T10494- , the
timing is NOK:
– Repeat control time settings.
If it is possible to insert the camshaft clamp -T10494- , the timing
is OK:
Octavia III 2013 ➤ , Octavia III 2014 ➤
1.2/63; 77 kW TSI engine - Edition 11.2014
97
2. Toothed belt drive