Skoda Octavia III 2013 Workshop Manual page 36

Octavia III 2013 ➤ , Octavia III 2014 ➤
1.2/63; 77 kW TSI engine - Edition 11.2014
– Connect support bracket - T30099- together with the other el‐
ements, as shown in the illustration.
– Attach spindle snap hook to the engine suspension eye.
– Pre-tension engine/gearbox unit with the spindle, do not raise.
– Release screws -arrows- and remove gearbox mount -1-.
Install
Installation is carried out in the reverse order. When installing,
observe the following:
Note
Screws which have been tightened firmly to a torque angle must
be replaced.
Caution
There is a risk of damaging the thread in the gearbox support
bracket by positioning the bolts obliquely.
♦ Before screwing in the screws -arrows 1- the gearbox
support bracket and supporting arm of the gearbox mount
must be absolutely parallel to each other. If necessary,
push up gearbox at the rear using a hydraulic trolley jack.
♦ Do not remove support bracket - 10-222 A- until the bolts
securing the assembly mounting have been tightened to
specified torque.
– Lift gearbox with the support bracket spindle until the gearbox
support bracket is touching the supporting arm of the gearbox
mount.
– Check assembly bracket setting
⇒ "2.4 Check assembly bracket setting", page 31
– Disconnect support bracket - 10-222 A- from engine.
Tightening torques
♦ ⇒ "2.1 Unit mounting - summary of components", page 26
♦ ⇒ "2.1 Assembly overview - air filter housing", page 238
♦ ⇒ "8 Engine control unit", page 268
♦ Battery tray ⇒ Electrical system; Rep. gr. 27
30
Rep. gr.10 - Removing and installing engine
.