Skoda Octavia III 2013 Workshop Manual page 58

Octavia III 2013 ➤ , Octavia III 2014 ➤
1.2/63; 77 kW TSI engine - Edition 11.2014
– Grip assembly device - T10134- on clamping surface -A- of
the threaded spindle in a vice -1-.
– Push assembly cup -C- down so that it rests on the nut -B-
-arrow-.
• The inside of the assembly device and assembly cup must be
at the same level.
– Remove securing clip -arrow- from new sealing flange.
Note
Do not twist rotor or take it out of the sealing flange.
• Locating hole -A- on sender wheel -C- must align with marking
-B- on sealing flange.
– Place sealing flange with front side facing down on a clean
level surface.
– Press down sealing lips supporting ring -1- in
-direction of the arrow-, until it rests on the level surface.
52
Rep. gr.13 - Crankshaft group