Skoda Octavia III 2013 Workshop Manual page 139

– Rotate oil pump gear to a position where 2 opposing notches
-arrows- are aligned vertically, as shown in the illustration.
– Fit oil pump onto dowel pins.
Tightening torques
– Tighten the new fixing screws -1- to 8 Nm + torque a further
1
90° ( / 4 turn).
– Tighten securing bolts -2- to 20 Nm.
– Install the new gasket ring for the crankshaft on the belt pulley
side
⇒ "1.6 Renewing crankshaft oil seal - belt pulley end",
page 44 .
– Installing the oil pan
⇒ "1.2 Removing and installing oil sump", page 128
– Install generator ⇒ Electrical System; Rep. gr. 27 .
– Mount tensioning element using new securing bolts -arrows-
and tighten to 20 Nm + 90° (
– Install toothed belt
⇒ "2.5 Removing and installing toothed belt", page 99
.
1
/ 4 turn).
Octavia III 2013 ➤ , Octavia III 2014 ➤
1.2/63; 77 kW TSI engine - Edition 11.2014
.
133
1. Lubrication system